Products

MAG 832

• Magnet with high holding power for safe operation
• Also suitable for working on vertical, sloping and overhead surfaces when used in conjunction with the safety chain supplied
• Accurate and clean-cut holes. Motor and slide plate form a single unit.
• Vertical feed by rack and pinion
• The motor will only start once the power supply to the magnet is switched on
• The use of broach cutters as hole cutters means that material has only to be removed from the periphery of the hole and so less force is needed to feed the bit and less power to rotate it. The central plug of material remaining in the bit after cutting is ejected by the spring-loaded pilot pin when the bit is removed from the hole
• Two speeds. High speed for cutting holes with broach cutters up to about 16 mm dia. and for drilling with normal bits up to 13 mm dia.; low speed for hole-cutting with broach cutters up to 32 mm diameter
• Metabo S-automatic safety clutch
• Chuck holder for working with twist drills available as optional accessory
• Torque 50 in-lbs / 19 in-lbs

• Max. broach cutter diameter 32 mm
• Magnetic stand:
  Max. depth of feed 130 mm
  Input 50 watts
  Max. magnetic holding power 8000 N
  Dimensions of magnet 90 x 170 mm
• Motor:
  Rated input 800 watts
  Output power 450 watts
• No-load speeds 530 rpm/1400 rpm
• Speeds at rated load 320 rpm/850 rpm
• Spindle thread 5/8"-16 UN
• Hole-cutting and drilling unit:
  Height including motor, with slide plate in
  lowermost position 405 mm
  uppermost position 525 mm
• Weight 14 kg